Get to an elevated command prompt, and type the following command. Here is the command I used to fix my problem. Apparently, the recent Windows Update removed this rule.Īlthough it is possible to put the rule into Windows Firewall using the interface provided by Microsoft, I like working from the command prompt.

After investigating on the internet and the Brother printer site I found that UDP port 54925 needed an inbound rule in Windows Firewall, to allow scanning from the scanner. For more info, contact your administrator.Īfter turning off the Windows Firewall, I could once again scan from the scanner to the PC. If your device is connected to a network, network policy settings might prevent you from completing these steps.

To turn it on, under Microsoft Defender Firewall, switch the setting to On.

If there’s an app you need to use that’s being blocked, you can allow it through the firewall, instead of turning the firewall off. Turning off Windows Defender Firewall could make your device (and network, if you have one) more vulnerable to unauthorized access. To turn it off, under Microsoft Defender Firewall, switch the setting to Off.Select the Start > Settings > Update & Security > Windows Security and then Firewall & network protection.To turn Microsoft Defender Firewall on or off: To verify this I temporarily disabled the Windows Firewall.įirst, you should check if this is your problem by temporarily turning off Windows Firewall. I suspected a firewall setting had been removed by a recent Windows Update. However, I could not scan when standing at the scanner. I could scan by going to the PC and using Brother utilities. Recently after a Windows update (I’m using version 1909 build 18363.836) I could no longer scan from the scanner to the PC. For example, I could scan a document from the printer/scanner to my local PC without a problem. I have a Brother HL-2280DW printer/scanner which has been working perfectly for several years.

Brother scanner firewall windows 10